MiquDrill – fits every application

• High drilling speeds (cutting speeds and feed rates)
• No or minimum chip removal cycles

• Tungsten carbide drill for greater challenges also as a version with high-performance coating
• MiquDrill carbide drill bits reach a significantly longer tool life with similar feed rates as HSS drills

• Short chips: especially polished cutting edge
• Clearly defined drilling process and adapted program with centering drill and follow-up drill

• Shorter machining time: MiquDrill drills, operating at similar feed rates as HSS drills, are much faster since higher cutting speeds can be reached
• Reduced tool wear due to high-performance coating
• High degree of reliability
• Cost-effective drill program, universally applicable

• Precision drill diameter: h6
• High position accuracy with centering drill or short drill and follow-up drill
• High degree of roundness
• High degree of alignment accuracy

MiquDrill Centro – the NC first drill for the hole to be positioned correctly right

• Diameter of 0.5 mm to 6 mm (.0197ˮ to .236ˮ)  (for follow-up holes from 0.1 mm (.0039“))
• Optional tip angle of 90° or 120°
• Diameter tolerance drill h6
• Uncoated/coated

MiquDrill 200 – the accurate short drill and pilot drill for deep follow-up holes

• Drill bit sizes from 0.1 mm to 1.5 mm (.0039ˮ to .059ˮ)
• Increments every 0.01 mm (.0004ˮ)
• Tip angle: 120°
• Diameter tolerances: drill h6, shaft h7
• Uncoated/coated (from 0.3 mm (.0118ˮ))
• Usable length 1.4 x d – 2.4 x d (depending on the diameter)

MiquDrill 210 – the universal drill where quality is the standard

• Diameter from 0.1 mm to 3 mm (.0039ˮ à .118ˮ)
• Increments every 0.01 mm (.0004ˮ) to diameter of 2 mm (.0787ˮ), afterwards every 0.05 mm (.0019ˮ)
• Tip angle: 120°
• Diameter tolerances: drill h6, shaft h7
• Uncoated/coated (from 0.3 mm (.0118ˮ))
• Usable length 2.4 x d to 8 x d (depending on the diameter)

• MiquDrill means Mikron Tool quality in the production of small and medium size batches  with a range of variants at a high degree of precision
• Complete drilling program which covers the entire spectrum from centering to finish-drilling
• Drills in diameters from 0.1 mm (.0039ˮ) and in the smallest increments (from 0.01 mm (.0004ˮ))
• All three MiquDrill industrial drills are made of tungsten carbide, have two cutting edges and are right hand cutting
• Suitable for many different metals; as a best drill bit for steel MiquDrill is a cost-effective alternative to the high-performance drill CrazyDrill Steel; especially suitable for the machining of small and medium size batches and where small increments are required
• All drills are available uncoated (from drill diameter of 0.1 mm (.0039ˮ)) and coated (from drill diameter of 0.3 mm (.0118ˮ))
• All MiquDrill drill bits are produced with highest repeat precision. Hence the user will benefit from long term stable production conditions (stable process and machining precision)